Symmetric Offset Options dialog box

Specifies the width of the slot.

Specifies the radius applied to concave sharp corners on the slot.

Displays the available cap type options.

Specifies that the cap type be a line.

Specifies the radius applied to flat cap corners. This option is available only when the Cap Type is set to Line.

Specifies that the cap type be an arc.

Specifies that the cap type be an offset arc.

Allows you to turn off the radii if the fillet radius is set to zero, which will result in sharp convex corners.

Displays the dialog box every time you select the command. If you do not want to display the dialog box when you select the command, clear this option.