Draw a polygon


  1. Choose the Polygon by Center command .

  2. Use the command bar to set the polygon options, such as:

    • The number of sides.

    • Whether the polygon is drawn by vertex or midpoint of a side.

  3. Click where you want the center of the polygon (1).

  4. Click to define the vertex or midpoint of the polygon (2) or you can enter a value in the edit boxes.

    Note:

    The By Vertex option circumscribes a circle about the polygon.

    The By Midpoint option inscribes a circle in the polygon.

Tip:

  • In 3D documents, a polygon consists of a series of connected lines that are constrained to a circle. In a draft document, the polygon circle is not created.

Draw command (sketch) Polygon by Center command

© 2021 UDS