Display Configuration Options dialog box
- Fit view after apply
-
Fits the view after the display configuration is applied.
- List exploded configuration in modeling mode. When applied:
-
Options for displaying exploded configurations outside of Explode Render Animate environment:
- Prompt for action
-
Gives you the choice to apply display settings only, or enter the ERA environment.
- Apply display settings only
-
Applies the display settings which are not unique to the ERA environment without entering ERA.
- Switch to ERA and explode
-
Switches to the ERA environment and applies the saved display configuration settings.
- Use single default configuration
-
Creates a QY CAD default configuration rather than a default configuration associated with a user name.
- Ignore configuration setting and activate components as follows
-
Sets the behavior of the display configuration to do one of the following:
- Activate all parts
-
Sets all the assembly components as active.
- Inactivate all parts
-
Sets all the assembly components as inactive.
- Maintain current state (recommended for best performance)
-
Specifies that the current activation state (active or inactive) of the parts in the assembly is not changed when you apply a display configuration. Setting this option improves performance when working with large assemblies.
If you want to change the current activation or override setting when applying a display configuration, you must apply the configuration using the Display Configurations dialog box.
- Ignore configuration setting and simplify components as follows
-
Allows you to specify how you want to apply the display configuration. When this option is set, you can specify whether the parts in the assembly are simplified or designed when you apply the display configuration. When this option is cleared, the simplified or designed status of the parts is determined by their status when the configuration was saved.
- Use all simplified parts (when available)
-
Specifies that the simplified version of parts is used when you apply the configuration.
- Use all design parts and assemblies
-
Specifies that the designed version of parts is used when you apply the configuration.
- Maintain current state (recommended for best performance)
-
Specifies that the current simplified state (simplified or as designed) of the parts in the assembly is not changed when you apply a display configuration. Setting this option improves performance when working with large assemblies.
If you want to change the current activation or override setting when applying a display configuration, you must apply the configuration using the Display Configurations dialog box.
© 2021 UDS