Copy, cut, and paste sketch elements
Sketch elements can be manipulated using the Microsoft clipboard behavior.
-
Ctrl+C copies the selected sketch elements to the clipboard.
-
Ctrl+X deletes the selected sketch elements from the model and adds them to the clipboard.
-
Ctrl+V pastes the selected sketch elements in the model.
Paste behavior
A paste operation places the sketch elements (clipboard) onto the locked sketch plane at the location clicked. At this point, the paste elements are attached to the cursor and each click places another copy paste elements on the locked plane.
If there is no locked sketch plane, the sketch elements are placed onto the plane highlighted under the cursor at the location clicked. At this point, the paste elements are attached to the cursor and each click places another copy of the paste elements on the locked plane.
To select another plane to paste to, end the paste operation with the Esc key. Press Ctrl+V again to restart the paste operation, and then select the new plane.
© 2021 UDS