Horizontal and vertical relationship command bar

Connected Faces

Specifies how the faces connected to the selection adapt during the modification.

• Extend/Trim

  Modifies the model by trimming and extending adjacent faces.

• Tip

  Modifies the model by allowing the current orientation of connected faces to change. In some situations, this can cause the current orientation of connected faces to tip or change their angle.

Clash

Specifies how the selected seed faces interact with the model during modification.

• Select set override

  Gives priority to selected and other moving faces over non moving faces.

• Model override

  Gives priority to non moving faces.

Keypoints

Specifies the type of keypoints located by the operation.

Alternate alignment plane

Places a plane to define alternate alignment of horizontal and vertical.

Persist

Specifies that the applied relationship is maintained if the model is modified later. When the Persist option is set, the relationship is applied, and a relationship entry is added to the Relationships collector in PathFinder. To modify the position of the faces independently later, you can delete the relationship entry from PathFinder.

When the Persist option is cleared, the relationship is applied, but the faces are free to move later, and no relationship is added to PathFinder.

You can also delete a persisted relationship. See Using the Advanced Design Intent panel for more information.

Accept

Accepts the operation.

Cancel

Cancels the operation.