Drawn Cutout command

Constructs a drawn cutout.

In the ordered environment, if you use an open profile, the open ends of the profile must theoretically intersect part edges. A closed profile cannot touch any part edges. Drawn cutouts cannot be flattened.

In the synchronous environment, the geometry used to create the cutout can be a closed internal profile that creates a region or an open profile extended to a part edge to create a closed region.

In the synchronous environment, regions that are valid for drawn cutouts are:

• Single

  

• Disjoint

  

• Contiguous

  

• Coincident to a sketch or edge

  

• Nested contiguous

  

You can select multiple regions at one time and the regions must all lie on the same plane.

---